If the ambient temperature is low, the selector
lever position display on the multi informa-
tion display may blink when the selector
lever is placed in the “D” (DRIVE), “Ds”
(DOWNSHIFT & SPORTY DRIVING), “L”
(LOW) or “R” (REVERSE) position immedi-
ately after the engine has been started. This
indicates that the transmission requires warm-
ing up. While the display is blinking, the
vehicle will not move, because the transmis-
sion keeps disengaging until the warm up is
completed even if the selector lever is placed
in the “D”, “Ds”, “L” or “R” position.
When the selector lever position display is
blinking, perform the following procedure:
1. Depress the brake pedal with your right
foot and place the selector lever in the
“N” (NEUTRAL) position for several
seconds.
2. Keep depressing the brake pedal and then
place the selector lever in the “D”
(DRIVE), “Ds” (DOWNSHIFT &
SPORTY DRIVING), “L” (LOW) or “R”
(REVERSE) position. If the selector lever
position display stops blinking, the warm
up is completed and the transmission will
function normally.
3. If the display is still blinking, repeat steps
1 and 2 above.
N00560501076
[For vehicles equipped mono-color liquid
crystal display meter]
When the selector lever position indicator
blinks while you are driving, there could be a
malfunction in the automatic transmission
system or CVT fluid temperature becomes
abnormally high.
If a malfunction occurs in the CVT while
driving, the indicator will blink.
In this case, immediately park your vehicle
in a safe place and follow these procedures:
[If the indicator blinks rapidly (once per sec-
ond), the CVT fluid is overheating.]
Park your vehicle in a safe place but do not
turn off the engine. Move the selector lever
to the “P” (PARK) position and open the
bonnet. Keep the engine, idling.
After a while, move the selector lever into
any position other than “P” (PARK) position
and confirm that the indicator stops blinking.
It is safe to continue driving if the indicator
no longer blinks.
If the indicator continues blinking or blinks
intermittently, have your vehicle inspected
by an authorized Mitsubishi Motors dealer.
[If the indicator blinks slowly (once per 2
seconds), the CVT safety device may be
operating due to a malfunction.]
Have the vehicle inspected by an authorized
Mitsubishi Motors dealer as soon as possi-
ble.
BK0223400US.book 74 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
To Next Page
Loading...
Need help?
General
