S-AWC (Super-All Wheel Control) (if so equipped)
5-84 Features and controls
N00542501058
The S-AWC operation status can be displayed
on the information screen in the multi-infor-
mation display.
To display the status, press the multi-informa-
tion meter switch to change the information
screen.
Refer to “Information screen (when the oper-
ation mode in ON)” on page 5-132.
The S-AWC operation status is displayed.
If the selected drive mode indicator begins
blinking, the drive mode will automatically
switch to protect the drive-system compo-
nents. A warning will also be displayed in
the information screen in the multi informa-
tion display.
Warning display
Reduce speed and, if the indicator stops
blinking, you may resume normal driving.
If the drive mode indicator (4WD) is blink-
ing, a problem has occurred with the S-
AWC. A warning will also be displayed in
the information screen in the multi informa-
tion display.
Warning display
Have your vehicle inspected by an autho-
rized Mitsubishi Motors dealer.
Make sure that all four tires are the same
specified size, type, and brand, and have no
significant difference in the amount of wear
for all 4 wheels. Otherwise, the S-AWC sys-
tem may not work properly, and a 4WD sys-
tem warning (overheating or service
required) may be displayed.
S-AWC operation display
Display example
Yaw control function display
The amount of the yaw moment is displayed
as a bar graph.
A, D- Clockwise yaw moment about the
vehicle’s center of gravity
B, C- Counterclockwise yaw moment
about the vehicle’s center of gravity
Differential limiting function display
The strength of the differential limiting
operation (between front-rear wheels and
between left-right wheels) is displayed in
section E of the meter as a bar graph.
Always concentrate on your driving first.
Keep your eyes and mind on the road. Dis-
tractions while driving can lead to an acci-
dent.
BK0223400US.book 84 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
To Next Page
Loading...
Need help?
General
