warnings when your vehicle is leaving or has
left the lane.
N00578000028
Every time the operation mode is turned to
“ON”, the LDW will automatically be turned
on and the “LDW” indicator will appear on
the information screen of the multi-informa-
tion display,
N00581000035
To turn off the LDW, press the LDW switch.
The “LDW” indicator on the information
screen of the multi-information display will
then go out.
To return the LDW to “ON”, press the LDW
switch again.
Never rely solely on the LDW. The LDW is
not a collision avoidance system and is not
a substitute for your safe and careful driv-
ing.
Before using the LDW, read this entire
section to understand the limitations of
this system. Failure to follow instructions
could result in an accident.
Turning on the LDW
Turning off the LDW
When you set the operation mode to “OFF”
with the system “OFF,” the system will be
restored “ON.” (“LDW 1” mode)
You can also select the “LDW 2” mode
which makes always the LDW system in
‘OFF state’.
1. Press the LDW switch, and the system is
placed in the ‘OFF state’.
2. Press and hold the LDW switch for more
than approximately 10 seconds. The
“LDW 2” indicator appears on the multi
information display.
3. Press the LDW switch, and the “LDW”
indicator on the top-right of the multi
information display goes out.
To return to the “LDW 1” mode, put the sys-
tem in ‘OFF state’, press and hold the LDW
switch for more than approximately 10 sec-
onds. The “LDW 1” indicator appears on the
multi information display.
BK0223400US.book 117 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
To Next Page
Loading...
Need help?
General
