Mitsubishi 2016 OUTLANDER User Manual

Tire pressure monitoring system
Features and controls 5-123
5
 A window tint that affects the radio wave
signals is installed.
N00532900081
If new wheels with new tire inflation pressure
sensors are installed, their ID codes must be
programmed into the tire pressure monitoring
system. Have tire and wheel replacement per-
formed by an authorized Mitsubishi Motors
dealer to avoid the risk of damaging the tire
inflation pressure sensors. If the wheel
replacement is not done by an authorized
Mitsubishi Motors dealer, it is not covered by
your warranty.
N00584300026
In case that 2 sets of tire inflation pressure
sensor ID are registered in the receiver, the
valid tire ID set can be changed by following
procedure.
[For vehicles equipped with color liquid crys-
tal display meter]
1. Operate the multi information display
switch to switch the information screen to
the menu screen.
Refer to “Multi information display
switch” on page 5-129.
Refer to “Changing the function settings”
on page 5-140.
2. Lightly press the multi information dis-
play switch to select “ ” (tire
ID set change).
3. Hold down the multi information display
switch for about 3 seconds or more. The
setting changes to the selected tire ID set.
4. The valid tire ID set is changed, and the
number of the tire pressure monitoring
system (TPMS) SET indicator is changed.
[For vehicles equipped with mono-color liq-
uid crystal display meter]
1. Transit the display by multi information
display switch until the tire pressure mon-
itoring system (TPMS) SET indicator is
displayed.
NOTE
 Tire inflation pressures vary with the ambi-
ent temperature. If the vehicle is subjected to
large variations in ambient temperature, the
tire inflation pressures may be under-inflated
(causing the warning light / display come on)
when the ambient temperature is relatively
low. If the warning light / display comes on,
adjust the tire inflation pressure.
Whenever the tires and wheels
are replaced with new ones
CAUTION
 The use of non-genuine wheels will prevent
the proper fit of the tire inflation pressure
sensors, resulting air leakage or damage of
the sensors.
Tire ID set change
NOTE
 Each time this procedure is done, the tire ID
set is changed. (1 - 2 - 1 - 2 …)
 The tire ID set is NOT changed, in case that
only 1 set of ID is registered.
BK0223400US.book 123 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
Information Provided by:

Mitsubishi 2016 OUTLANDER Specifications

General

Brand	Mitsubishi
Model	2016 OUTLANDER
Category	Automobile
Language	English