Mitsubishi 2016 OUTLANDER User Manual

Multi Information display - Type 2
Features and controls 5-149
5
N00575301030
This displays the average fuel consumption
from the last reset to the present.
The reset mode conditions for the average
fuel consumption display can be switched
between “Auto reset” and “Manual reset”.
For information on how to change the aver-
age fuel consumption display setting, refer to
“Changing the function settings” on page
5-152.
N00556501121
Shows the temperature outside the vehicle.
N00579000025
If the outside air temperature drops below
approx. 37 °F (3 °C), the alarm sounds and
the outside air temperature warning symbol
(A) flashes for about 10 seconds.
 When you refuel, the driving range display is
updated.
However, if you only add a small amount of
fuel, the correct value will not be displayed.
Fill to a full tank whenever possible.
 When your vehicle is stopped on an
extremely steep hill, the driving range value
may, change. This is due to the movement of
fuel in the tank and does not indicate any
breakdown.
 The display setting can be changed to the
preferred units (miles or km).
Refer to “Changing the function settings” on
page 5-152.
Average fuel consumption dis-
play
NOTE
NOTE
 The average fuel consumption display can be
reset separately for the auto reset mode and
for the manual reset mode.
 “---” is displayed when the average fuel con-
sumption cannot be measured.
 The initial (default) setting is “Auto reset
mode”.
 Average fuel consumption may vary depend
on the driving conditions (road conditions,
how you drive, etc.). The actual fuel con-
sumption may differ from the fuel consump-
tion displayed, so treat the fuel consumption
displayed as just a rough guideline.
 Disconnecting the battery cable will erase
from memory the manual reset mode or auto
reset mode setting for the average fuel con-
sumption display.
 The display setting can be changed to the
preferred units {mpg, km/L, L/100 km}.
Refer to “Changing the function settings” on
page 5-152.
Outside temperature display
NOTE
 The display setting can be changed to the
preferred units (°F or °C).
Refer to “Changing the function settings” on
page 5-152.
 Depending on factors such as the driving
conditions, the displayed temperature may
vary from the actual outside temperature.
Frozen road warning
BK0223400US.book 149 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
Information Provided by:

Mitsubishi 2016 OUTLANDER Specifications

General

Brand	Mitsubishi
Model	2016 OUTLANDER
Category	Automobile
Language	English