Mitsubishi 2016 OUTLANDER User Manual

Warning lights
Features and controls 5-173
5
N00520300147
N00520401536
This light comes on when the ignition switch
is turned to the “ON” position (engine off) or
the operation mode is put in ON.
When the engine is started, the light should
go off a few seconds later. A warning is also
displayed in the multi information display.
The warning light also illuminates after start-
ing the engine under the following condi-
tions.
 When the parking brake is still applied.
 When the brake fluid level is low.
 When the brake system circuit is not
working properly.
When the vehicle is moving at more than 5
mph (8 km/h) and parking brake applied, a
buzzer will sound to inform the driver that the
parking brake is not properly release.
Before driving, be sure that the parking brake
is fully released and brake warning light is
off.
N00520501814
This indicator is a part of the onboard diag-
nostic (OBD) system which monitors the
emissions, engine control system or auto-
matic transaxle control system/continuously
variable transmission (CVT) control system.
If a problem is detected in one of these sys-
tems, this indicator illuminates or flashes.
When the ignition switch is turned to the
“ON” position or the operation mode is put in
ON, this indicator normally comes on and
goes off after the engine has started.
This indicator will come on if the fuel tank
filler cap is not properly tightened. If this
indicator comes on and stays on after refuel-
ing, stop the engine and check that the cap is
properly tightened. (Turn the cap clockwise
until you hear clicking sounds.)
If this indicator does not go off after several
seconds or lights up while driving, have the
system checked as soon as possible at an
authorized Mitsubishi Motors dealer or a
repair facility of your choice.
Warning lights
Brake warning light and buzzer
CAUTION
 If the brake warning light and the Anti-lock
braking system warning light are illuminated
at the same time, the braking force distribu-
tion function will not operate, so the vehicle
may be destabilized during sudden braking
under the following conditions.
• When the brake warning light does not go
out even when the parking brake is
released.
• When the brake warning light stays on
while driving.
• If the above occurs, avoid sudden braking
and high-speed driving. Park the vehicle in
a safe place, and contact an authorized Mit-
subishi Motors dealer or a repair facility of
your choice as soon as possible.
 The vehicle should be brought to a halt in the
following manner when brake performance
is deteriorated.
• Confirm that the vehicle slows down when
you press down on the brake pedal harder
than usual. In some cases, the brake pedal
may go all the way to the floor.
• Should the brakes fail, use engine braking
to reduce your speed and slowly apply the
parking brake.
Depress the brake pedal to illuminate the
stop lights to alert the vehicles behind you.
Engine malfunction indicator
(“SERVICE ENGINE SOON”
or “Check engine light”)
BK0223400US.book 173 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
Information Provided by:

Mitsubishi 2016 OUTLANDER Specifications

General

Brand	Mitsubishi
Model	2016 OUTLANDER
Category	Automobile
Language	English