Mitsubishi 2016 OUTLANDER User Manual

HomeLink® Wireless Control System (if so equipped)
Features and controls 5-223
5
3. Press and release - every 2 seconds
(“cycle”) your hand-held transmitter until the
HomeLink
®
indicator light changes from
slowly flashing orange to either rapidly flash-
ing green (rolling code) or continuously lit
green (fixed code). Now you may release the
hand-held transmitter button.
Proceed with “Programming a new Home-
Link
®
” step 4 to complete.
N00584900022
The HomeLink
®
has the capability of receiv-
ing garage door status from compatible
garage door opener systems. Check your
garage door opener manual for the available
feature and HomeLink
®
compatibility. Also
for a listing of compatible systems contact
HomeLink
®
at: www.homelink.com
1. Within 5 seconds after successfully pro-
gramming the garage door opener (refer
to “Programming a new HomeLink
®
”
section), both garage door operation indi-
cators (A) will flash rapidly green indicat-
ing that the garage door feedback has
been enabled.
If the indicators do not flash, perform
steps 2 and 3 while pressing the Home-
Link
®
button up to the first 10 times after
successful programming.
2. Press and release the programmed Home-
Link
®
button to activate the door. You
now have 1 minute in which to complete
step 3.
3. Once the door has stopped, press and
release the “Learn” or “Smart” button on
the garage door opener (refer to your
garage door opener owner’s manual for
the location of the “Learn” button). Both
the HomeLink
®
garage door operation
indicators will flash rapidly green upon
successful synchronization with the door
opener (within 5 seconds).
N00585000020
To operate, simply press and release the pro-
grammed HomeLink
®
button. Activation will
now occur for the trained device (i.e. garage
door opener, gate operator, security system,
entry door lock, home/office lighting, etc.).
For convenience, the hand-held transmitter of
the device may also be used at any time.
N00585200022
The HomeLink
®
has the capability of receiv-
ing garage door status from compatible
garage door opener systems. Refer to “Addi-
tional steps for programming a door system
with feedback” on page 5-223.
Garage door status is then displayed with
indicators (A).
NOTE
 If programming a garage door opener or gate
operator, it is advised to unplug the device
during the “cycling” process to prevent pos-
sible overheating.
Additional steps for program-
ming a door system with feed-
back
Operating HomeLink
®
Garage door feedback
BK0223400US.book 223 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
Information Provided by:

Mitsubishi 2016 OUTLANDER Specifications

General

Brand	Mitsubishi
Model	2016 OUTLANDER
Category	Automobile
Language	English