N00849701296
1. Open the liftgate and use the bar to
remove the cover (A) over the tire hanger
mounting bolt.
2. With the wheel nut wrench, loosen the tire
hanger mounting bolt by turning it coun-
terclockwise.
3. Lift up the section of the tire hanger (B)
that is marked with the arrow in the illus-
tration and remove it from the hook (C).
Then lower it and remove the tire.
N00849801457
1. On vehicles with wheel covers, first
remove the covers (refer to “Wheel cov-
ers” on page 8-13). Then, loosen the
wheel nuts with the wheel nut wrench. Do
not remove the wheel nuts yet.
2. Place the jack under one of the jacking
points (A) shown in the illustration. Use
the jacking point closest to the tire you
wish to change.
Do not use tire chains with your compact
spare tire. Using a chain could cause damage
to your vehicle and loss of the chains.
To remove the spare tire
While checking the tire hanger, carefully
loosen the tire hanger mounting bolt. Loos-
ening it too much could pull out the hook and
cause the compact spare tire to drop.
When hooking or unhooking the tire hanger,
be sure to hold the tire hanger firmly to pre-
vent it from dropping on your foot.
To change a tire
BK0223400US.book 8 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
To Next Page
Loading...
Need help?
General
