How to change a tire
8-12 For emergencies
N00832300020
1. Place the tire on the center of the tire
hanger, with the wheel surface facing
upwards.
2. Lift up the tire hanger (A) and hook it on
the hook (B).
3. With the wheel nut wrench, firmly tighten
the tire hanger mounting bolt by turning it
clockwise.
4. Install the cover over the tire hanger
mounting bolt.
N00850001172
Store the flat tire in the luggage compartment.
Reverse the removing procedure when stor-
ing the jack, bar and wheel nut wrench.
Refer to “Jack and tools” on page 8-5.
To store the spare tire
Storing the tire with the wheel surface facing
down may damage the wheel or tire hanger.
If you find any damage on a spare tire, do not
use the tire and contact an authorized Mit-
subishi Motors dealer or a repair facility of
your choice.
Make sure you hook the tire hanger in the
proper position. If the tire hanger is not
hooked properly, the hook could damage the
vehicle body or the tire could fall off the
vehicle while driving, causing an accident.
Confirm that the tire hanger is firmly secured
after storing the spare tire. If the tire hanger
is not secured, it could drop out while driv-
ing, causing an accident.
When hooking or unhooking the tire hanger,
be sure to hold the tire hanger firmly to pre-
vent it from dropping on your foot.
To store the flat tire, jack, bar
and wheel nut wrench
BK0223400US.book 12 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
To Next Page
Loading...
Need help?
General
