Mitsubishi 2016 OUTLANDER User Manual

Keyless entry system (if so equipped)
Features and controls 5-11
5
4. Within 60 seconds after step 3, complete
the following ID code registration opera-
tion using the next remote control trans-
mitter you wish to register within 4
seconds.
i) Press both the LOCK and UNLOCK
buttons for 2 seconds.
ii) Release both the LOCK and UNLOCK
buttons for 1 second.
iii) Press the UNLOCK button. The
answerback function informs you that the
ID code registration of the transmitter is
completed.
5. To register the ID codes of additional
remote control transmitters, repeat step 4
within 60 seconds after step 4.
6. If no ID code of a remote control trans-
mitter is registered within 60 seconds
after step 4, the registration mode is can-
celed and the normal mode returns.
N00546101124
Your keyless entry system operates on a radio
frequency subject to Federal Communica-
tions Commission (FCC) Rules (For vehicles
sold in U.S.A.) and Industry Canada Rules
(For vehicles sold in Canada). This device
complies with Part 15 of FCC Rules and
Industry Canada licence-exempt RSS stan-
dard(s).
Operation is subject to the following two con-
ditions.
 This device may not cause harmful inter-
ference.
 This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE
 For verification purposes, try to lock and
unlock the doors after the registration is
completed.
 The indicator light (4) comes on each time a
button is pressed.
 The keyless entry system does not work if
the key is in the ignition switch.
 The remote control transmitter can be used
from about 40 feet (12 m) away. However,
this distance may change if your vehicle is
near a TV transmitting tower, a power sta-
tion, or a radio station.
 If the following conditions are observed after
pressing the LOCK (1) or UNLOCK (2) but-
ton on the remote control transmitter, the
battery in the remote control transmitter may
need to be replaced.
• The doors and the liftgate cannot be locked
or unlocked.
• The panic alarm cannot be operated.
• The indicator light (4) is dim or does not
come on.
 If you lose your remote control transmitter,
please contact an authorized Mitsubishi
Motors dealer for a replacement.
 If you wish to obtain an additional remote
control transmitter, please contact an autho-
rized Mitsubishi Motors dealer. A maximum
of 8 remote control transmitters can be pro-
grammed for your vehicle.
 To use the new remote control transmitters, it
is necessary to register the key with both the
electronic immobilizer and keyless entry sys-
tem.
Also refer to “Electronic immobilizer (Anti-
theft starting system): Customer key pro-
gramming” on page 5-6.
NOTE
General information
CAUTION
 Changes or modifications not expressly
approved by the manufacturer for compli-
ance could void the user’s authority to oper-
ate the equipment.
BK0223400US.book 11 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
Information Provided by:

Mitsubishi 2016 OUTLANDER Specifications

General

Brand	Mitsubishi
Model	2016 OUTLANDER
Category	Automobile
Language	English