ENGINE <4G6> -
Oil Pan
11A-19
OIL PAN
11200280207
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
D Engine Oil Draining and Supplying (Refer to GROUP
12 - On-vehicle Service.)
D Oil Level Gauge Removal and Installation
D Front Exhaust Pipe Removal and Installation (Refer
to GROUP 15.)
f 4 ± 1mm
Bolt
hole
Groove
5
9Nm
9Nm
5
2
3
1
Sealant:
MITSUBISHI GENUINE PART
MD970389 or equivalent
4
7Nm
Removal steps
1. Drain plug
"
A
A
2. Drain plug gasket
3. Bell housing cover
4. Oil level sensor
A
A
"
5. Oil pan
REMOVAL SERVICE POINT
A
A
"
OIL PAN REMOVAL
After removing the oil pan mounting bolts, remove the oil
pan with the special tool and a brass bar.
Caution
Perform this slowly to avoid deformation of the oil pan
flange.
INSTALLATION SERVICE POINT
"
A
A
DRAIN PLUG GASKET INSTALLATION
Install the drain plug gasket in the direction so that it faces
as shown in the illustration.
MD998727
MD998727
Drain plug
gasket
Oil pan side
To Next Page
Loading...
