ENGINE <4D6> -
Service Specifications/Sealants
11C-3
Items LimitStandard value
Power Tension N When checked 294 - 490 -
steering oil
pump drive
When a used belt is installed 343 - 441 -
belt tension
When a new belt is installed 490 - 686 -
Deflection When checked 12.6 - 16.3 -
mm
When a used belt is installed 13.4 - 15.3 -
When a new belt is installed 10.0 - 12.6 -
A/C com- Tension N When checked 392 - 588 -
pressor
drive belt
When a used belt is installed 441 - 539 -
tension
When a new belt is installed 637 - 833 -
Deflection When checked 9.2 - 12.0 -
mm
When a used belt is installed 9.8 - 11.2 -
When a new belt is installed 7.0 - 8.6 -
Valve clearance (at hot) Intake valve 0.35 -
mm
Exhaust valve 0.45 -
Injection timing (Dial gauge display value mm) 1 ± 0.03
(10_ATDC)
-
Idle speed r/min 800 ± 30 -
Compression pressure kPa 3,500 Min. 2,560
Compression pressure difference of all cylinder
(at engine speed of 280 r/min) kPa
- Max. 300
Cylinder head bolt shank length mm - 99.4
Timing belt deflection mm 4-5 -
Timing belt B deflection mm 5-7 -
SEALANTS
11100050362
Items Specified sealants Remarks
Oil pan MITSUBISHI GENUINE PART
MD970389 or equivalent
Semi-drying sealant
Semi-circular packing and rocker
cover seal, and cylinder head seal
3M ATD Part No.8660 or equivalent
Flywheel bolt or adapter plate bolt 3M Stud Locking 4170 or equivalent -
To Next Page
Loading...
