ENGINE <6A1> -
Camshaft and Camshaft Oil Seal
11B-16
<Rear bank>
Pre-removal and Post-installation Operation
D Air Intake Plenum Removal and Installation
(Refer to GROUP 15.)
D Timing Belt Removal and Installation
(Refer to P.11B-26.)
D Distributor Removal and Installation
(Refer to GROUP 16.)
D Drive Belt Tension Adjustment (Refer to P.11B-5.)
Apply engine oil to all
sliding parts when
installing.
3.4 Nm
1
2
6
7
9
12
13
8
28 - 34 Nm
88 Nm
Removal steps
1. Breather hose connection
2. Blow-by hose connection
6. Spark plug cable
7. Rocker cover
A
B
""
C
A
8. Camshaft sprocket
"
B
A
9. Camshaft oil seal
A
C
"
12. Rocker arm and shaft assembly
"
A
A
13. Camshaft
REMOVAL SERVICE POINTS
A
A
"
RADIATOR UPPER HOSE/RADIATOR LOWER
HOSE DISCONNECTION
After making mating marks on the radiator hose and the hose
clamp, disconnect the radiator hose.
To Next Page
Loading...
