MITSUBISHI ELECTRIC 7011A SERIES UPS
MITSUBISHI
ELECTRIC
7011A SERIES UPS
OWNERS / TECHNICAL MANUAL
Page Number:
vii
CAUTION
PRECAUTIONS FOR INSTALLATION
PRECAUTIONS FOR INSTALLATIONPRECAUTIONS FOR INSTALLATION
PRECAUTIONS FOR INSTALLATION
• Do not block the intake/exhaust ports. Install the UPS at least 4” (10cm) away from
walls, etc.
-If the intake/exhaust ports are blocked, the internal temperature of the UPS will rise and
could lead to fires from battery electrolyte leakage, fire ignition or part deterioration.
• Follow the UPS instruction manual carefully when installing the unit.
-Improper installation could lead to injury such as the UPS falling over, etc.
PRECAUTIONS FOR WIRING
PRECAUTIONS FOR WIRINGPRECAUTIONS FOR WIRING
PRECAUTIONS FOR WIRING
• The power supply for this unit must be single phase rated in accordance with the
equipment data plate. It must be suitably grounded.
-Failure to ground the unit could lead to electrical shocks.
PRECAUTIONS
PRECAUTIONSPRECAUTIONS
PRECAUTIONS FOR USE
FOR USEFOR USE
FOR USE
• If a unit fault, abnormal odor or noise occurs, turn off the UPS input switch.
-Failure to do so could lead to fires.
• Do not insert blunt objects or fingers, etc., in the fan.
-Failure to observe this could lead to injuries.
• Do not insert blunt objects or fingers, etc., into the unit's input/output section.
-Failure to observe this could lead to electrical shocks.
• Ventilate the UPS surroundings.
-Failure to do so could lead to container rupture or to explosions from the gas generated
from the battery system.
• Prohibit smoking and the use of fire around the unit.
-Failure to do so could lead to injuries, damage or fires from explosions.
• Do not place containers that have water or any liquids on the UPS.
-If the container tips over and the water or liquids spills, this could lead to electrical shocks
and to fires in the UPS.
• Do not sit on, step on or lean on the UPS.
-Failure to observe this could lead to injuries if the UPS tips over.
To Next Page
Loading...
Need help?
General
