Mitsubishi FREQROL-SFJ - 3.3.1 (B) Status display and parameter setting for ROM versions after BO

3.3.1 (B) Status display and parameter setting for ROM versions
after "BO"
(1) Readout and switches
I
MODE
If P DOWN
SET
I ’
Located on card SFJ-CA1
a)
b)
c)
d)
e)
"Operation status",
"dia-
gnosis",
"error alarm",
"parameter setting (1) -
(8)" and "debug" can be
displayed.
Function of each switch is
as follows:
MODE:
UP :
DOWN:
SET :
Display mode can be
changed.
Value displayed in
ADDRESS and DATA can
be incremented.
Value displayed in
ADDRESS and DATA can
be decremented.
Data set for paramet-
er is stored when
this switch is pres-
sed.
12 display modes, namely, "operation status", "diagno-
sis", "error alarm",
"parameter setting (1) - (8)" and
"debug", are selectable.
After turning on the power, "motor speed" is displayed
automatically unless alarm occurs.
In case of alarm, alarm code is displayed.
Display mode can be changed by pressing kdswitch.
For display mode sequence and display content, refer
to the chart on the next page.
. .
- 20 -