Mitsubishi FREQROL-SFJ - Diagnosis Display Mode; External I;O Signals; Operation Status Display Mode

(3) Operation status display mode
In operation status display mode,
codes listed below are
displayed.
Item
Code
Unit
Description
Motor speed I-
rpm
Motor speed is displayed.
Reference -
I_
rpm
Commanded reference motor speed is
speed
displayed.
Position
Pulses
Number of 'remaining pulses (delay
control
pulses) on deviation counter is
droop
%
displayed.
For pulses (minus) in reverse rota-
tion,
decimal point lights.
--
Load
I_
%
Load condition is displayed (100%
for 30min.
rated output).
(4) Diagnosis display mode
In diagnosis display mode, "control sequence", "external
signal", "warning NO.",
"parameter error No." and "alarm
No." can be displayed.
Item Display
Description
Control
,- c
_I -
0 1-l - Indicates that the controller
sequence -
ID" DATA
is ready for operation.
I- ,=: -
I:1 I-
Indicates that the'controller
ADD
nlfl
is not ready for operation.
(5) External I/O signals . . . . .
I/O signal can be monitored.