Mitsubishi FREQROL-SFJ - 3.9 Parameter list

3.9 Parameter list
c
Parameter
Description
Set;A;&)range
01 NOX Motor type
Set "0".
Decimal nota-
tion
02 MSL Motor sel-
SJ-J2.2A . . . . . 0
Decimal nota-
ection
SJ-J3.7A . . . . . 1
tion
SJ-J5.5A . . . . . 2
SJ-J7.5A . . . . . 3
03 PLG Position
Setting is made for number of
Decimal nota-
control
encoder pulses.
tion
loop
encoder
0: 1024 pulses (encoder oriented
type
spindle stop, sync. TAP)
04 MOD External
Setting depends on interface with
Decimal nota-
interface NC.
tion
mode sel-
ection
0: Decimal IO (CON1 signal is
used for operation)
2: Bus-line connection to M300
series CNC
05 DSR Digital
Type of digital speed reference
Decimal nota-
speed re-
signal is selected.
tion
ference
This parameter is valid when MOD
signal type (#04) is set llo,,.
0: 12-bit binary
1: Signed 12-bit binary
2: BCD (2-digit)
3: BCD (3-digit)
06 MON Output
Type of meter for monitor (MO2
Decimal nota-
monitor
output of CONl) is set.
tion
selection
0: Load meter
1:
Torque meter
Standard setting: 0
07 OlSL Auxiliary
0: Speed detection ON
0 -- 4
output 1
selection
1: Torque limit ON
2: Spindle control ready
3: Emergency stop ON
4: Alarm ON
08 02SL Auxiliary 0: Speed detection ON 0 -4
output 2
selection
1: Torque *limit ON
2: Spindle control ready
3: Emergency stop ON
4:
Alarm ON
- 42 -