Mitsubishi FREQROL-SFJ - Parameter Setting

f
(2) Parameter setting
Set parameters with READY signal (SET) turned off.
o Motor speed is displayed
(Fig.
1) when alarm does
not occur.
ADD
DATA
Fig.
1 Motor speed
display
0 Each time @ switch is pressed, ADDRESS and
DATA alternate.
'0 Desired address can be selected in ADD section
Selecting the
by pressing morH switch.
Data at the
selected address is displayed in DATA section.
(G&p->
Note:
If display in ADD
section does not
change,
but DATA
f;;=$$;~~:,
press w switch t;
Fig. 2
I 1
*
changemode from
DATA to ADDRESS.
(Data at address
"02 II
is displayed
Ex.:
In example shown
in **.)
in Fig. 1, ADD dis-
play changes to S I when
cl
UP switch is
pressed, and to
SZ when the switch is
pressed again (Fig. 2).
o Display in
DATA section can be incremented
or decremented by pressing
@*or @ switch.
to set desired value for DA
o E;tB;zzsing a switch, the set data can be
.
o After the desired data has been set, press
mlfll
E
switch on card SFJ-CA1 or turn off and
en on the power to reset FR-SFJ.
Now data setting (parameter setting) has been
completed.
f
- 19 -