– 9 –
F DGB
PRE-OPERATION ENGINE INSPECTION
INSPECTION AVANT EMPLOI
Effectuez ces vérifications avant de démarrer le moteur.
1Vérification du carburant
•
Est-cequeleréservoirdecarburantcontientdel’essence?
•
Est-cequel’essenceutiliséeestusagée?
•
Faitesleplein avecducarburant normalcomme indiqué
auparagraphe“CARBURANTETHUILEMO-TEUR”
de la page 7.
• Est-cequelebouchonduréservoirdecarburantestrevis-
sécorrectement?
AVERTISSEMENT
•
Prenez gardeaufeuquandvousfaitesle pleinetquand
vous transportez
le carburant. Un incendie ou une explo-
sion pourrait se produire si vous ne suivez pas cet aver-
tissement.
2Vérification du filtre à air
•
Est-cequelefiltreàairestsaleouest-cequel’huiledufil-
treàairestenquantitéinsuffisante(typeàbaind’huile)?
• Lorsquelefiltreàairestsaleoulors-quel’huiledufiltreà
airestsaleouenquantitéinsuffisante,effectuezl’in-spec-
tion et l’entretien en suivant les indications données aux
paragraphes“ENTRETIENDUMOTEUR”page13et
“INSPECTIONETENTRE-TIEN”page19.
3Vérification de l’huile moteur
• Est-cequeleniveaud’huileestnor-mal?Ouest-ceque
l’huileestsale?
• Lorsqueleniveaud’huileestbasoulorsquel’huileest
saleouaétéutiliséeau-delàdelapériodespécifiée,effec-
tuez l’inspection et l’entretien en sui-vant les indications
donnéesauxpara-graphes“CARBURANTETHUILE
MOTEUR”page7et“ENTRE-TIENDUMOTEUR”
page 13.
4Vérification du serragedes boulons
• Est-cequelesboulonssontbienserrés?
• Vérifieztoujourslesboulonsdefixationdusilencieux.
(Danscecas,assurez-vousquelesilencieuxn’estpas
chaudavantdecommencer.)
5Nettoyage et inspection de toutes les pièces
• Est-cequ’ilyadel’herbe,desfeui-llesouautresmatéri-
auxinflammablesattachésausilencieux?
• Est-cequ’ilyadel’herbe,desfeuillesouautresmatéri-
auxinflammablesattachésàlaprised’entréed’airdulan-
ceuràrappel?
S’ilyadelapoussière,etc.vousdevezl’enleveravantde
démarrer le moteur.
6Vérification des fuites d’huile et de carburant
• Est-cequ’ilyadesfuitesd’huileoudecarburant?
Sivousentrouvez,faitesfairelesréparationsrequises.
7
•
Quantités
de carburant et d’huile pour chaque
modèle
8Modèle
9Capacité du réservoir de carburant
0Volume
d’huilemoteur
Sicherstellen, daß folgende Punkte vor dem
Betrieb des Motors geprüft sind.
1Treibstoffprüfung
•
IstBenzinimT
ank?
• IstdasbenutzteBenzinalt?
•
DenAnweisungenaufSeite7“TREIBSTOFFUND
MOTORÖL” folgen und den richtigen Treibstoff einfül
-
len.
•
IstderT
ankdeckel
richtiggeschlossen?
WARNUNG
• AusreichendVorsichtwaltenlassen(Hitzeund
Flamme) beim Umgang mit Treibstoff.
Zuwiderhandlung könnte zu einem Feuer oder zur
Explosion führen.
2Luftfilterinspektion
•
Ist das Filterelementschmutzig oderdas Luftfilter-Öl
(Ölbadtyp)ausreichend?
•
WenndasFilterelementschmutzigistoderdasÖlim
Luftfilter schmutzig
oder unzureichend ist, gemäß
Seite
13“MOTORPFLEGE”undSeite19
“INSPEKTIONUNDW
ARTUNG”
prüfenundwarten.
3
Motorölinspektion
•
IstderMotormitderangegebenMengeÖlgefüllt?
UndistdasÖlschmutzig?
• FallsnichtgenügendÖlvorhandenist,dasÖlschmut-
zig oder es für längere Zeit als angegeben benutzt
wurde,
denAnweisungenaufSeite7“TREIBSTOFF
UNDMOTORÖL”undSeite 13 “MOTORPFLEGE”fol-
gen.
4Die Festigkeit aller
Befestigungsschrauben prüfen.
•
SindalleSchraubenfestangezogen?
•
Sicherstellen,daßdieSchrauben,diezumBefestigen
des Auspuffs
benutzt werden, geprüft werden. Bei
kaltem Auspuff ausführen.
5Teilereinigungs-Prüfung
•
Befindet sichGras,BlätteroderBrennstofferund um
denAuspuff?
• BefindetsichGras, BlätteroderBrennstofferundum
denStarter
-Lufteinlaß?
Abfall, usw. rund um den Motor, vor dem Betrieb des
Motors entfernen.
6Inspektion nach Treibstoff-
und Ölundichtigkeiten
•
SindirgendwelcheUndichtigkeitenvorhanden?
Falls vorhanden, den Motor reparieren lassen.
7
• Normtankkapazität
und Ölmengen für ver-
schiedene Modelle
8Modell
9T
ankkapazität
0Motorölmenge
MOTORINSPEKTION VOR DER INBETRIEBNAHME
Be sure to check the following before operating the engine.
• Is there gasoline in the tank?
• Is old gasoline being used?
• Add the correct fuel following the instructions on
page 7 “FUEL AND ENGINE OIL”.
• Is the fuel tank cap closed correctly?
WARNING • Be sufficiently careful of heat and flame
when handling and adding fuel. Not
doing so could cause a fire or explosion.
1
Fuel inspection
• Is the air cleaner element dirty or is the air cleaner oil
(oil bath type) insufficient?
• When the air cleaner element is dirty or oil in the air
cleaner is dirty or insufficient, check and maintain
according to page 13 “CARE OF THE ENGINE” and
page 19 “INSPECTION AND MAINTENANCE”.
• Are there grass, leaves, or combus-tible materials
around the muffler?
• Are there grass, leaves, or combus-tible materials
around the recoil starter air intake?
If there is trash, etc., in the vicinity, be sure to
remove it before operating the engine.
2
Air cleaner inspection
• Is the engine filled with the specified amount of
engine oil? And is the oil dirty?
• If there is not enough oil, if it is dirty, or it has been
used longer than the specified time, follow the
inspection and maintenance instructions on page 7
“FUEL AND ENGINE OIL” and page 13 “CARE OF
THE ENGINE”.
3
Engine oil inspection
5
Component cleaning inspection
• Are there any fuel or oil leaks?
If any are found have the engine repaired.
6
Fuel and oil leaks inspection
• Are all the screws tight?
• Be sure to check the screws used to fasten the
muffler. (Do this when the muffler is cold.)
4
Inspect the tightness of all fastener screws.
3.1L
3.1L
0.55L
0.55L
0
Engine oil quantity
9
Fuel tank capacity
8
Model
7
• Standard fuel tank capacity and oil quantity for
the various models
GB13G
GB18G