3-188
Features and controls
3
System check screen
When the ignition switch is turned to the “ON” position, the
system check screen is displayed for about 4 seconds. If there
is no fault, information screen (when the ignition switch is
“ON”) is displayed.
If there is a fault, the screen changes to warning display. Refer
to “Warning display list (when the ignition switch is “ON”
position)” on page 3-219.
OTE
● The system check screen display varies depending on
your equipment.
Service reminder
When the time for periodic inspection arrives, the warning dis-
play is displayed for a few seconds after the screen that is ini-
tially displayed when the ignition switch is turned “ON”. Refer
to “Service reminder” on page 3-198.
Type 1
Type 2
Drive mode indicator display screen (if so equipped)
N00555900046
Shows the 4WD drive status.
Refer to “Drive mode-selector” on page 3-136.
ACD control mode display screen (if so equipped)
N00545900027
The operation status of the ACD control mode is displayed.
Refer to “ACD control mode” on page 3-133.
Type 1 Type 2
BK0138600US.book 188 ページ ２０１１年７月１７日 日曜日 午後２時３２分
To Next Page
Loading...
