3-156
Features and controls
3
The tire pressure monitoring system may not work normally in
the following circumstances:
● A wireless facility or device using the same frequency is
near the vehicle.
● Snow or ice is stuck inside the fenders and/or on the
wheels.
● The tire inflation pressure sensors’ battery is exhausted.
● Wheels other than Mitsubishi genuine wheels are being
used.
● Wheels that are not fitted with tire inflation pressure sen-
sors are being used.
● Wheels whose ID codes are not memorized by the vehicle
are used.
● Compact spare tire is fitted on a road wheel.
OTE
● Tire inflation pressures vary with the ambient tempera-
ture. If the vehicle is subjected to large variations in ambi-
ent temperature, the tire inflation pressures may be under-
inflated (causing the warning light to come on) when the
ambient temperature is relatively low. If the warning light
comes on, adjust the tire inflation pressure.
Whenever the tires and wheels are replaced with
new ones
N00532900065
If you use new wheels with new tire inflation pressure sensors,
their ID codes must be programmed into the tire pressure mon-
itoring system. Have tire and wheel replacement performed by
an authorized Mitsubishi Motors dealer to avoid the risk of
damaging the tire inflation pressure sensors. If the wheel
replacement is not done by an authorized Mitsubishi Motors
dealer, it is not covered by your warranty.
CAUTION
!
● The use of non-genuine wheels will prevent the
proper fit of the tire inflation pressure sensors,
resulting air leakage or damage of the sensors.
BK0102103US.book 156 ページ ２００９年１０月２６日 月曜日 午後１時３８分
To Next Page
Loading...
Need help?
General
