Mitsubishi LANCER User Manual

3-176
Features and controls
3
Auto reset mode
● When the average fuel consumption is being displayed, if
you hold down the multi-information meter switch, these
calculations will be reset to zero.
● When the ignition switch has been set to the “ACC” or
“LOCK” position for about 4 hours or more, the average
speed display will automatically reset.
N
OTE
● The average speed display and the average fuel consump-
tion display can be reset separately in both auto reset
mode and manual reset mode.
● “---” is displayed when the average fuel consumption can-
not be measured.
● The initial (default) setting is “Auto reset mode”.
● Average fuel consumption may vary depend on the driv-
ing conditions (road conditions, how you drive, etc.) The
actual fuel consumption may differ from the fuel con-
sumption displayed, so treat the fuel consumption dis-
played as just a rough guideline.
● The average fuel consumption display memories for auto
reset mode and manual reset mode are erased if the battery
is disconnected.
● The display setting can be changed to the preferred units
{mpg(US), mpg(UK), L/100 km or km/L}.
Refer to “Changing the function settings (With ignition
switch in the “ON” position)” on page 3-184.
Momentary fuel consumption display
While driving, the momentary fuel consumption is shown with
a bar graph.
When the momentary fuel consumption surpasses the average
fuel consumption, the momentary fuel consumption is dis-
played with a green bar graph. (Type 2)
Be conscious of maintaining the momentary fuel consumption
above the average fuel consumption, it can help you drive with
the better fuel consumption.
N
OTE
● When the momentary fuel consumption cannot be mea-
sured, a bar graph is not shown.
● The display setting can be changed to the preferred units
{mpg (US), mpg (UK), L/100 km or km/L}.
Refer to “Changing the function settings (With ignition
switch in the “ON” position)” on page 3-184.
● It is possible to cancel the green bar graph.
Refer to “Changing the function settings (With ignition
switch in the “ON” position)” on page 3-184.
Function setting screen
The “Display language”, “Temperature unit”, “Fuel consump-
tion unit”, and “Average fuel consumption and speed reset
method” settings can be modified as desired.
For further details, refer to “Changing the function settings
(With ignition switch in the “ON” position)” on page 3-184.
BK0102103US.book 176 ページ ２００９年１０月２６日 月曜日 午後１時３８分

Mitsubishi LANCER Specifications

General

Brand	Mitsubishi
Model	LANCER
Category	Automobile
Language	English