STARTING WSTEM
- Starter Motor
8-97
STARTER MOTOR
REMOVAL AND INSTALLATION
NOBFJAE
16-19 Nm 16-19 Nm
12-l? ft.lbs. 12-14 ft.lbs.
15W1564
Removal steps
1. Air filter
2. Connection of starter motor connector
l * 3. Starter motor
NOTE
(1) Reverse the removal procedures to reinstall.
(2) ++ : Refer to “Service Points of Installation”
6EL05(
This test must be performed quickly (in less than 10 sec-
onds) to prevent coil from burning.
D
Revision
INSPECTION
PINION GAP ADJUSTMENT
I, Disconnect field coil wire from “M” -terminal of magnetic
switch.
2. Connect a 12V battery between “S” -terminal and “M” -
terminal.
3. Set switch to “ON”, and pinion will move out.
Caution
To Next Page
Loading...
