Mitsubishi Montero 1987 - Buzzer; Reed Switch; Combination Meter Removal and Installation

8-134
METERS AND GAUGES - Combination Meter
COMBINATION METER
REMOVAL AND INSTALLATION
NOBHJAF
Removal steps
1. Meter cover
l 4 2.
Connection
3. Meter asset
of speedometer cable
nbly
NOTE
(I) Reverse the removal procedures to reinstall.
(2) l + : Refer to “Service Points of Installation”.
16W1553
I
1 I
I
f
16W1645
INSPECTION
REED SWITCH
Using an ohmmeter, check that continuity and discontinuity
alternate between terminals 1 and 2 four times at every
rotation of the shaft of the speedometer cable connection.
BUZZER
Check to be sure that buzzer sounds when the battery’s
positive (+) terminal is connected to terminal 2 and the
battery’s negative (-) terminal is connected to terminal 1.
[ STB Revision