8-122
IGNITION SYSTEM
- Ugnition Switch
IGNITION SWITCH
REMOVAL AND INSTALLATION
Removal steps
1. Lower column cover
2. Upper column cover
3. Cable band
4.
Ignition switch
5. Key remaind switch
NOTE
Reverse
the
removal procedures to reinstall
NOEGLAE
16W1557
16UO36C
!I
INSPECTION
(1) Disconnect the wiring connector
from the ignition switch,
and connect an ohmmeter
to the
switch side connector.
(2) Operate the switch, and check the continuity between the
terminals.
START /
Ignition switch
NOTE
O-C indicates that there is continuity between the terminals.
1 STB Revision -7
To Next Page
Loading...
