Mitsubishi Montero 1987 - Blower Switch Inspection; Removal of Mode Selection Control Wire; Removal of Air Selection Control Wire

24-10
HEATERS I- Heater Control
2ow7a7
VIOVAL OF AIR SELECTION CONTROL WIRE
Use a screwdriver to pry and remove the clip that holds
the outer cable of the air selection control wire.
Disconnect the inner cable of the air selection control
wire from the end of the recirculation/fresh-air change-
over damper lever.
9. REMOVAL OF MODE SELECTION CONTROL WIRE
(1) While using a screwdriver to pry the clip that holds the
outer cable of the mode selection control wire, pull the
/ outer cable to remove it from the clip.
(2) Disconnect the inner cable of the mode selection
control wire from the end of the mode selection
damper lever.
10. REMOVAL OF WATER VALVE CONTROL WIRE
(1) Use a screwdriver to pry and remove the clip that holds
the outer cable of the water valve control wire.
(2) Disconnect the inner cable of the water valve control
wire from the end of the water valve control lever.
INSPECTION
BLOWER SWITCH
N24GCAC
Operate the switch, and check the continuity between the ter-
minals.
Switch position
OFF
.
Terminal
214567
o--O
0
0
0 0
NOTE
O-O indicates that there is continuity between the terminals.
/ STB Revision
-7