Mitsubishi Montero 1987 - Reassembly of Signal Rotor; Adjustment of Air Gap; Reassembly of Breaker Plate; Reassembly of Driven Gear

IGNITION SYSTEM-Distributor
8-121
Distributor
w
\
6EL093
/” A
I -1--
Socket
17. REASSEMBLY OF DRIVEN GEAR
Install driven gear into distributor shaft at previously marked
location.
12. REASSEMBLY OF BREAKER PLATE
Install igniter base to housing. Position the igniter base so that
the projection (A) fits into the groove (9).
11. REASSEMBLY OF SIGNAL ROTOR
Install signal rotor to rotor shaft. Position the signal rotor so
that the dowel pin fits into the groove.
. ADJUSTMENT OF AIR GAP
Adjust air gap between signal rotor and pick-up of igniter.
Standard value : 0.8 mm (.0315 in.)
1 STB Revision