Mitsubishi Montero 1987 - Heater Control Removal and Installation; Removal of Glove Box Stoppers

HEATERS -
Heater Control
24-9
HEATER CONTROL
N24GA-
REMOVAL AND INSTALLATION
2QW824
Removal steps
4+
1. Glove box stoppers
++ ~~ 2. Air selection control wire
3. Knobs
4. Plugs
5. Center panel
6. Connection of center panel wiring har-
ness to front wiring harness connector
7. Lap heater duct (B)
8. Defroster duct
++ l + 9. Mode selection control wire
++ l + 10. Water valve control wire
l a II. Heater control assembly
12. Blower switch
EyTEeverse the removal procedures to reinstall.
(2) 4+ : Refer to “Service Points of Removal”.
(3) eq : Refer to “Service Points of Installation”.
SERVICE POINTS OF REMOVAL
N24GBAE
1. REMOVAL OF GLOVE BOX STOPPERS
(1) Open the glove box lid.
(2) Remove the glove box stopper.
(3) Pull the glove box outward.