Mitsubishi Montero 1987 - Installation of Wiper Arms; Low Speed Operation Check; High Speed Operation Check; Automatic Stop Operation Check

8-172
WIPER AND WAsHER SYSTEM - Windshield Wipers
nm (in.1 16Y1568 I
I
J
(v
L
I 2
Battery
II
I ,
+
Battery
@
16W1538
bv
J’ L
.jr 2.
Battery
3 4
I
16W1539
SERVICE POINTS OF INSTALLATION
2. INSTALLATION OF WIPER ARMS
Install the wiper arm to the pivot shaft so that the wiper
blade’s stop position is the position shown in the illustra-
tion.
INSPECTION
WIPER MOTOR
Disconnect the wiring connector from the wiper motor and
connect battery to the wiper motor connector to check that
the @viper motor runs.
LOW SPEED OPERATION CHECK
Connect battery ( + ) to terminal 1 and battery ( - ) to terminal 3
and check that the motor runs at low speed.
HIGH SPEEID OPERATION CHECK
Connect battery (+) to terminal 1 and battery (-) to terminal 4
and check that the motor runs at high speed.
AUTOMATIC STOP OPERATION CHECK
(1) Connect battery ( +) to terminal 1 and battery ( -) to
terminal 3 to run the motor at low speed.
(2) Disconnect terminal 1 during operation to stop the motor.
1 STB Revision
-7