8-10
INSPECTION OF HARNESS CONNECTOR
- Inspection of Harness Connector
Housing lance
-5
1
16R1321
’ Needle
16Ffi322
Housing lance
16R1323
(2) Insert harness of terminal to be rectified deep into connector
from harness side and hold it there.
(3)
Insert tip
of screwdriver [1.4 mm (.06 in.) width] into connector
in a manner as shown in the figure, raise housing lance slightly
with it and pull out harness.
NOTE
Tool No. 753787-l supplied by AMP can be used instead
of screwdriver.
(4) Insert needle through a hole provided on terminal and raise
contact point of male terminal.
ROUND WATERPROOF CONNECTOR
(1) Remove waterproof cap by using a screwdriver.
(2) Insert tip of screwdriver [1.4 mm (.06 in.) or 2.0 mm (.08 in.)
width] into connector in a manner as shown in the figure, raise
housing lance slightly with it and pull out harness.
(3) Insert screwdriver through a hole provided on terminal and
raise contact point of male terminal.
To Next Page
Loading...
