Mitsubishi MR-JE-200A - Page 241

6. APPLICATION OF FUNCTIONS
6 - 28
Setting example: When the sheet length is 200.0 mm, the circumferential length of the rotary knife
axis (synchronous axis length) is 600.0 mm, and the sheet synchronous width is 10.0 mm
Cam axis one cycle
current value
Sheet feeding
(0.0 mm)
180°
(100.0 mm)
360°
(200.0 mm)
Home position
0°
t
t
t
(5.0 mm)(5.0 mm)
Rotary knife axis (cam axis)
speed
Cam stroke ratio
(Cam data
created by
users)
0°
Synchronous speed
(Sheet feed speed)
Sheet length
(200.0 mm)
Sheet synchronous width
(10.0 mm)
Cycle length of the rotary
knife axis
(600.0 mm)
Rotary
knife axis
(Cam axis)
Sheet length
(200.0 mm)
100%
(600.0 mm)
Fig. 6.2 Driving example
Basic settings require to use the simple cam
function
Item Setting Setting value
Operation mode
selection ([Pr.
PA01])
Select "Point table
method".
"1006"
Simple cam
function setting
([Pr. PT35])
Enable the simple cam
function.
"_ 1 _ _"
Device setting Assign CAMC (Cam
control command input),
CAMS (Output in cam
control), and CI0 to CI3
(Cam No. selection 0 to 3)
with I/O setting parameters
([Pr. PD_ _ ]).
Refer to
section
7.2.4.
When the conveyor axis (main axis) feeds a
sheet by the set length, the rotary knife makes
one rotation (360 degrees) to cut the sheet. Set
the following items as follows.
Item Setting Setting value
Cam axis one
cycle length
([Cam control
data No. 48])
Set the sheet length.
200.000
Cam stroke
amount ([Cam
control data No.
51])
Set the rotation amount
per rotation in "degree".
360.000
Synchronous
encoder axis unit
([Cam control
data No. 14])
Set the unit of the sheet
length.
0 (mm)
Unit of rotary
knife axis ([Pr.
PT01])
Set "degree" as the unit of
position data.
"_ 2 _ _"
Cam data Create the cam data with
the operation pattern
shown in Fig. 6.2.
Set the following items as follows to use the
encoder following function.
Item Setting Setting value
Main shaft input
axis selection
([Cam control
data No. 30])
Select the synchronous
encoder axis.
2
Synchronous
encoder axis unit
multiplication:
Numerator
([Cam control
data No. 15])
Refer to the synchronous
encoder axis unit
conversion gear setting in
section 6.1.7 (3) (b).
Refer to
section
6.1.7 (3)
(b).
Synchronous
encoder axis unit
multiplication:
Denominator
([Cam control
data No. 16])