6. APPLICATION OF FUNCTIONS
6 - 61
(5) Using together with other functions
Availability of other functions during the interrupt positioning is as follows:
Function
Available
(Note 1)
S-pattern acceleration/deceleration
Stroke limit
Software limit
Temporary stop/restart
Speed change value
Analog override (Note 2)
Backlash
Rough match
Electronic gear
Roll feed display function
Mark detection function (current position latch function)
Note 1. : enabled, : disabled, : enabled with condition
2 Enabled only in a constant speed
ITP (Interrupt positioning) is available with the program function.
Because the interrupt positioning function with MSD (Mark detection) input signal is prioritized, the
interrupt positioning function with MSD (Mark detection) can be used during the interrupt positioning
function with ITP (Interrupt positioning). However, ITP (Interrupt positioning) cannot be used during the
interrupt positioning with MSD (Mark detection).
To Next Page
Loading...
