Mitsubishi S6R Series

10-1
Chapter 10 COOLING SYSTEM
1. Cooling System - Remove and Inspect ...............................................................10-3
1.1 Water Pump, Thermostat and Water Pipe - Remove and Inspect.......................................... 10-3
1.2 Heat Exchanger and Water Pipe - Remove and Inspect........................................................ 10-4
1.3 Sea Water Pump and Water Pipe - Remove and Inspect ...................................................... 10-5
1.4 Air Cooler Coolant Pump, Thermostat and Water Pipe - Remove and Insp........................... 10-6
2. Cooling System - Disassemble, Inspect and Assemble ....................................10-7
2.1 Tension Pulley - Disassemble and Inspect............................................................................. 10-7
2.2 Thermostat - Disassemble and Inspect .................................................................................. 10-8
2.3 Thermostat for Jacket Water and Air Cooler - Inspect.......................................................... 10-11
2.4 Heat Exchanger - Disassemble and Inspect......................................................................... 10-12
2.5 Water Pump - Disassemble and Inspect .............................................................................. 10-13
2.6 Water Pump - Inspect ........................................................................................................... 10-15
2.7 Water Pump Shaft - Inspect.................................................................................................. 10-15
2.8 Water Pump - Assemble....................................................................................................... 10-16
2.9 Air Cooler Water Pump - Disassemble and Inspect ............................................................. 10-19
2.10 Air Cooler Coolant Pump - Assemble ................................................................................... 10-22
2.11 Sea Water Pump - Disassemble and Inspect ....................................................................... 10-24
2.12 Sea Water Pump - Assemble ............................................................................................... 10-26
2.13 Fan Drive Assembly - Disassemble and Inspect .................................................................. 10-30
2.14 Fan Drive - Inspect ............................................................................................................... 10-31
2.15 Bushing Ring, Friction Rubber and Grommet - Inspect ........................................................ 10-31
2.16 Oil Seal Sleeve - Inspect ...................................................................................................... 10-31
2.17 Oil Seal Sleeve - Replace..................................................................................................... 10-31
2.18 Fan Drive - Assemble ........................................................................................................... 10-32
3. Cooling System - Install......................................................................................10-35
3.1 Water Pipe (Air Cooler) - Install ............................................................................................ 10-35
3.2 Water Pump and Sea Water Pump - Install.......................................................................... 10-35