13-1
Chapter 13 ADJUSTMENT AND OPERATION
1. Engine - Adjust ......................................................................................................13-3
1.1 Turning Gear - Use ................................................................................................................. 13-3
1.2 Valve Bridge and Adjusting Screw - Check ............................................................................ 13-4
1.3 Valve Clearance - Check ........................................................................................................ 13-4
1.4 Fuel Injection Timing - Check ................................................................................................. 13-4
1.5 Fuel System - Bleed Air .......................................................................................................... 13-4
1.6 Belt and Belt Tension - Inspect and Adjust............................................................................. 13-6
2. Break-in Operation ................................................................................................13-9
2.1 Preparation Before Engine Starting ........................................................................................ 13-9
2.2 Engine Start-up....................................................................................................................... 13-9
2.3 Break-in Operation.................................................................................................................. 13-9
3. Engine-Test and Adjustment..............................................................................13-11
3.1 Engine Performance Test..................................................................................................... 13-11
3.2 Emission Gas Test................................................................................................................ 13-11
3.3 Governor Performance Test ................................................................................................. 13-11
3.4 Alarm Action and Emergency Stop Tests ............................................................................. 13-11
3.5 Maximum Fuel Injection Volume - Set.................................................................................. 13-11
3.6 Seal ...................................................................................................................................... 13-12
To Next Page
Loading...
