13-10
Chapter 13 ADJUSTMENT AND OPERATION
2.3.2 Inspection while the Engine is Running
During the break-in operation, pay attention to followings and make sure that there is no abnormality.
Oil pressure and oil temperature
Coolant temperature and level
Leakage of oil, water, fuel and gas; especially oil from turbochrger pipe connection of lubricating oil.
Noise and vibration
Intake air pressure and temperature
Exhaust color and odor
Exhaust temperature
Differences between right and left banks
Blow-by gas (amount and color)
Rotational fluctuation
Face and radial runouts of rotating parts
Indication and operation of meter and alarm
2.3.3 Inspection and Adjustment After Break-in Operation
Valve clearance
Fuel injection timing
Bolts and nuts around the engine - retighten
Belt tension
Defects such as oil leakage - inspect and repair
To Next Page
Loading...
