- 17 -
3 Precaution for safety
1
5
2
6
3
7
9
4
8
10
• Use 4-core cabtyre cables (conductor
cross section with 5mm
2
or more) for
power cable. Do not connect it to
extension code.
( Refer to page 38.)
• Use MENNEKES Part no.6 (400V 32A)
for power supply plug.
• Pull out the power code by holding the plug
part at the end of the code.
• Check the plug of the power code for dust.
If there is no dust, insert it firmly.
• Surely protect the power socket
with a cover when it is not used.
When the cover is damaged, repair
it immediately.
• Otherwise, it may cause an electric shock or a fire
due to the heat, breaking of wire and leaking of
water, etc.
Do not start and stop the operation with pulling out or
inserting the power supply breaker or power code.
• Otherwise, it may cause troubles of electric circuit, damages of
power supply code or an electric shock.
To Next Page
Loading...
