Mitsubishi TU100SAE - Method to Stop Operation at each Room [Multiple Specification (TU100 SAEM) Only]

- 43 -
5 Operation
1
5
2
6
3
7
9
4
8
10
1・3・5
2・4・6
5
* Above gure applies to the 3-room
specication. ZONE C is not displayed
on the 2-room specication.
Method to stop operation at each room [Multiple specification (TU100SAEM) only]
1

In the “Clock/Calendar display mode”, hold down the “UP” or “DOWN”
switch till the display changes to the “Run/Stop select mode” (above figure).
2

Press the “SET” switch.
⇒
The display changes to the “Each room
Run/Stop setting mode”.
3

Press the “UP” or “DOWN” switch.
⇒
Select the room to stop operation. The
lamp of selected room starts to blink
and the mark
is displayed.
4

Press the “SET” switch.
⇒
The room to stop operation is finalized.
5

Press the “UP” or “DOWN” switch.
⇒
Operation is stopped at the selected room.
NOTE
●
You cannot stop operation at all rooms.
6

Press the “SET” switch.
⇒
Operation stop at the selected room is completed, and the display returns to
the “Run/Stop select mode”. If you need to stop operation at any other room,
repeat the steps 2 to 6.