- 55 -
6 Loading
1
5
2
6
3
7
9
4
8
10
Loading and unloading
Loading procedure
1
Stop the cooling operation. ( Refer to page 42.)
2
Load the cargoes in the container.
Leave a space between the cargo and inner wall of the container as shown
in the following figure in order to circulate cool air.
More than 100 mm
Evaporator
Lower than supply air outlet
More than 100 mm
50 – 75 mm
More than 30 mm
More than
30 mm
Supply air outlet
3
Keep the top layer of the cargo as flat as possible.
Waterproof the cargoes if they need to be.
• Water may drip or splash from the evaporator unit.
4
When transporting any cargo to be protected from water damage,
cover the cargo placed under the evaporator unit or near its outlet with
waterproof sheet.
5
After completing loading, start the operation of the refrigeration unit.
( Refer to page 41.)
To Next Page
Loading...
