- 59 -
7 Inspection
1
5
2
6
3
7
9
4
8
10
Opening the front panel of condensing unit
Front panel of condensing unit, which is opened and closed for inspection,
can be opened and closed without tool.
1
Open the latches provided at both
sides of front panel.
⇒
Locks are released and the front
panel comes out a little to this side.
2
Open the front panel by hand.
3
Insert the stay in the mounting hole on
the back of front panel to fix the panel.
⇒
Fixing angle of front panel can
be selected from 2 steps (90°and
135°).
Closing the front panel of condensing unit
1
Remove the stay and close the front panel.
２
Push the latches at both sides in and close the front panel.
⇒
It is locked.
3
Confirm that the front panel is locked completely.
NOTE
●
Unless the front panel is pushed in firmly, the locks will not catch properly.
In such occasion, the front panel may be opened during driving. Make
sure to lock the panel securely.
Latch
Front panel
To Next Page
Loading...
