- 73 -
9 For emergency
1
5
2
6
3
7
9
4
8
10
Resuming operation after an emergency stop
If a remark "Automatic operation resume" is written in the column for the Unit
Condition in the list of alarm codes, the operation will resume as soon as required
conditions are satisfied. If a remark "Unit stops" is written in the same column,
start the operation in usual procedure after removing causes of the troubles.
Resuming operation after an emergency stop
●
Press the [RUN/STOP] switch on the cabin controller to stop the unit.
(Confirm that the LCD display is turned off.)
●
Press the [RUN/STOP] switch once more to resume the operation of unit.
If the unit stops by the same trouble immediately after
the operation is resumed, stop the operation and
contact your nearest dealer.
• Otherwise, it may cause serious damages or accidents.
To Next Page
Loading...
