Mitsubishi TU100SAE - Displaying the Operation Time;Cycles

- 32 -
4 Initial setting
1
5
2
6
3
7
9
4
8
10
Displaying the operation time/cycles
１
２・5・6
３・４・5・6
1

Press the [MODE] switch.
⇒
The display changes to the "Clock/calendar display mode".
2

Press the [UP] or [DOWN] switch until
the display changes to the "Operation
time/cycles display mode". (Right
figure)
3

Press the [SET] switch.
⇒
The digital display changes to the
engine operation time (for engine oil
inspection) mode.
Icon

starts to blink if the
maintenance request time has been
reached.
4

Hold down the [SET] switch.
(If you release hand, it returns to the
original display.)
⇒
The current engine operation time (for
engine oil inspection) is displayed
on the digital display. The lower
digital display is up to 4 digits while
the upper digital display shows the
number of the fifth digit.