Mitsubishi TU100SAE - Page 38

- 33 -
4 Initial setting
1
5
2
6
3
7
9
4
8
10
5

To clear the operation time, hold down
the [SET] and [DOWN] switches for 3
seconds. (If you release hand, it returns
to the display at Step 3.)
⇒
Icon
goes out.
NOTE
●
Clear the operation time after replacing
engine oil.
●
When the icon
has lighted in any other
mode, contact your service shop.
6

Press the [UP] or [DOWN] switch.
⇒
The display changes to each of following modes.
While the [SET] switch is held down, the operation time or start/stop
cycles in each mode is displayed.
User is allowed to clear
only.
Engine operation time
(Engine oil inspection)
SV2-A solenoid valve
start/stop cycles
SV8 solenoid valve
start/stop cycles
SV4 solenoid valve
start/stop cycles
SV5 solenoid valve
start/stop cycles
EEV-A on/off cycles
DH-A operation time
Hot water pump
operation time
WSV-A solenoid valve
start/stop cycles
EH-A operation time
Evaporator fan 1
operation time
Evaporator fan 2
operation time
Evaporator fan 3
operation time
Evaporator fan 4
operation time
Engine operation time
Motor operation time
Cooling water belt
operation time
Cooling water working
time
Main belt operation time
Alternator operation time
Engine operation time
(Overhaul)
Starter start/stop cycles
Fuel pump operation
time
Compressor electromagnetic
clutch operation time
Compressor electromagnetic
clutch start/stop cycles
Throttle solenoid start/stop
cycles
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
Digital display
Mode
Order of
display
Upper
section
Lower
section
Digital display
Mode
Order of
display
Upper
section
Lower
section