Mitsubishi TU100SAE - Forced Fuel Circulating Method

- 35 -
4 Initial setting
1
5
2
6
3
7
9
4
8
10
1・5
2・4
3・5
Forced fuel circulating method
1

Press the [MODE] switch.
⇒
The display changes to the “Clock/calendar display mode”.
2

Press the [UP] or [DOWN] switch
until the display changes to the “Fuel
circulation mode”. (Right figure))
3

Press the [SET] switch.
⇒
On the digital display, “
” or “
” blinks.
also blinks.
4

Press the [UP] or [DOWN] switch to
select “
”.
5

Press the [SET] switch.
⇒
The display changes to show the fuel
circulation on and the remaining time (in
minute) alternately at each 2 seconds.
Fuel circulation is completed 10 minutes later and the display returns to the
“Normal display screen”. (
24 page)
To interrupt the fuel circulation, press the mode switch to return to the “Fuel
circulation mode”.
NOTE
●
If fuel is used up, air may intrude in the fuel system such as the fuel hose, etc, so that the engine may
become unable to start. In such occasion, purge air in the fuel circulation mode before starting engine.