EasyManua.ls Logo

Mitsubishi TU100SAE - Loading; Inspection; Operation or Stop for Long Period of Time; For Emergency

Mitsubishi TU100SAE
86 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- IV -
1
5
2
6
3
7
9
4
8
10
Manual defrost operation ------ 47
Starting ------------------------------- 47
Stopping ----------------------------- 47
Setting the ON timer ----------- 48
Setting the OFF timer ---------- 50
Self diagnosis operation
(PTI operation) ------------------ 52
Starting the operation -------------- 52
Finishing the operation when no
defects are detected --------------- 53
When abnormal conditions are
detected ----------------------------- 53
6 Loading ------------------ 54
Preparation before loading ---- 54
Loading and unloading -------- 55
Loading procedure ----------------- 55
Unloading ---------------------------- 56
7 Inspection ---------------- 57
Precautions for inspection ---- 57
Opening the front panel of
condensing unit ----------------- 59
Closing the front panel of
condensing unit ----------------- 59
Daily inspection ----------------- 60
Inspection of cooling water quantity
-- 60
Inspection of moving sections ---- 61
Inspection of engine oil quantity --- 62
Inspection of engine fuel quantity
--- 63
Inspection of leakage and wiring
condition ----------------------------- 63
Inspection of condenser coil ------ 64
Periodic inspection ------------- 65
Periodic inspection check sheet
-- 66
Details of applicable oils and
cooling water-------------------- 68
Power supply system ---------- 68
8 Operation or stop for long
period of time ------------ 69
When operating at a low inside container
temperature for a long period of time:
-- 69
When stopping the refrigeration unit for
a long period of time:
------------------- 69
9 For emergency ---------- 70
Alarm display ------------------- 70
Switching "Normal display" and
"Current alarm display" -------- 70
Switching from "Normal display screen"
to "Current alarm display mode"
------ 70
Extending "Current alarm display
mode"
--------------------------------- 70
Switching from "Current alarm display
mode" to "Normal display screen"
-- 70
Countermeasures--------------- 71
Changing the fuse ------------------ 71
When you contact your nearest
dealer --------------------------------- 72
Resuming operation after an
emergency stop
------------------ 73
List of alarm codes ------------- 74
10 Specification ------------- 77

Table of Contents

Related product manuals