Mitsubishi TU100SAE - Page 50

- 45 -
5 Operation
1
5
2
6
3
7
9
4
8
10
2・41
3・5
* Above gure applies to the 3-room specication.
ZONE C is not displayed on the 2-room specication.
1

Start to operate the refrigeration unit. (
Refer to page 41.)
⇒
Display changes at every 4-seconds to show the setting temperature/inside
room temperature at each room.
2

Press the [UP] or [DOWN] switch.
⇒
Select the room to set the temperature.
Lamp of the selected room blinks with
mark
3

Press the [SET] switch.
⇒
Current setting temperature on the
upper digital display starts to blink.
4

Press the [UP] or [DOWN] switch to
change the temperature.
NOTE
●
Each press on the [UP] switch increases the value by
0.5 while each press on the [DOWN] switch decreases
the value by 0.5. (In case of Fahrenheit by 1)
Keeping pressing either switch changes the value
continuously.
5

Press the [SET] switch.
⇒
The setting is completed and the screen returns to the "Normal display
screen". (
Refer to page 24.)
■Multiple specification (TU100SAEM)