To Next Page

To Previous Page

EN-38

ITEM SETTING FUNCTION

SCART INPUT ON / OFF Choose ON when connecting the projector with a device equipped

with the SCART terminal that can output RGB signal. SCART

terminal is used mainly in Europe. Choose OFF normally. (Available

only for the input signal from the COMPUTER/COMPONENT VIDEO

IN-1 terminal.)

LAMP WARNING

STANDARD

When the lamp operating time exceeds 3000 hours with LAMP

MODE set to LOW, a warning dialog is displayed.

SHORT TERM

When the lamp operating time exceeds 3800 hours with LAMP

MODE set to LOW, a warning dialog is displayed.

HIDE OSD

OFF

Select this option for normal use.

The no-signal dialog, input dialog, SCART warning dialog, auto

power-off dialog, lamp warning dialog, and abnormal temperature

dialog aren’t displayed.

LAMP 1 TIME RESET OK The LAMP 1 operation time is reset to 0.

LAMP 2 TIME RESET OK The LAMP 2 operation time is reset to 0.

FILTER TIME RESET OK The ﬁlter operation time and the cleaning count is reset to 0.

RESET ALL OK The menu settings are reset to the factory defaults (except the

LANGUAGE, PASSWORD FUNCTION, IMAGE CAPTURE, and

NETWORK settings).

• CINEMAMODEcanbeadjustedonlywhenaTV60,TV50,480i,576ior1080isignalisbeingdisplayed.

• WhenSCARTINPUTissettoON,normalcomputersignalsaren’t projected.

• UseacommerciallyavailableSCART-MiniD-SUB15-pincablewhenconnectingthisprojectorwithanAVdeviceequipped

with the SCART terminal.

• SomeAVdevicesequippedwiththeSCARTterminalaren’t compatible with this projector.

• TheRESETALLprocessmaytakesometimetocomplete.

• YoucannotcarryoutRESETALLforapprox.2minutesafterthelampswitchingorthelamprelayoperation.

FEATURE menu (continued)

Menu operation (continued)

Mitsubishi UD8350 User Manual

Questions and Answers: