Mitsubishi WD385U-EST

Questions and Answers

B
Bailey BartlettAug 29, 2025
Why are my Mitsubishi WD385U-EST images shaking or displaced?
- C
  Christopher BoydAug 29, 2025
  If the images projected by your Mitsubishi Projector are shaking or displaced, first check that the cable connecting the projector to the external device isn’t intermittent. Ensure the cable's plug is firmly connected to the external device's connector. Then, press the AUTO POSITION button. Note that some computers may output out-of-spec signals; in this case, adjust the Signal menu. If the input signal is a WXGA video signal, confirm the setting selected in WXGA in the Option menu; otherwise, select Off.
R
richard55Aug 27, 2025
Why does my Mitsubishi Projector ask for a password?
- M
  Michael BrownAug 27, 2025
  If your Mitsubishi Projector is displaying a password screen, it means the password lock feature has been enabled in the Password menu. To proceed, you will need to enter the correct password. If you do not know the password, contact the person responsible for managing the projector.
C
cody57Aug 27, 2025
What to do if my Mitsubishi Projector shows no image on the screen after turning it on?
- G
  Gregory StantonAug 27, 2025
  If your Mitsubishi Projector shows no image after turning it on, try these steps: First, cancel AV mute by pressing the AV MUTE button. Check that the lens cap is removed. Note that it can take about 1 minute for the lamp to light up. If the projector was turned off before the lamp cooled down sufficiently last time, the fan may start rotating and the POWER button may not work after the power cord is plugged. Press the POWER button to turn back on the POWER indicator. Ensure the intake vent is clean and the lamp cover is closed. Check the cables connected to external devices for damage. If using an extension cable, replace it with the supplied cable to check for improvement; if images display correctly, consider adding an RGB signal amplifier to the extension cable.
A
amataAug 25, 2025
How to fix a Mitsubishi WD385U-EST displaying 'No signal'?
- A
  amolinaAug 26, 2025
  If your Mitsubishi Projector displays a 'No signal' message, first ensure that the connected device is powered on and functioning correctly. Check if the external device is outputting signals, especially if it's a notebook computer. Verify that the cable connecting the projector to the external device is not defective and is connected to the correct terminals. Also, confirm that the connected device is correctly selected as the input source. If using an extension cord, try replacing it with the supplied cable to see if that resolves the issue; if it does, consider using an RGB signal amplifier with the extension cord.