3 Setting Parameters
18
No. 99MBC109B
3.4.2 Details of Display Mode Selection (Parameter
Number 06)
On 2-axis models, Display mode can be selected by setting parameter number
06 as follows:
Set value Display mode
BANK1 BANK2
CEL1 CEL2 CEL3 CEL4
0
(Default value)
Coordinate
display
UNIT A
(Count A)
UNIT B
(Count B)
UNIT A
(Count A)
UNIT B
(Count B)
1
Sum/Difference
calculation display
UNIT C
(A ± B)
UNIT A
(Count A)
UNIT C
(A ± B)
UNIT B
(Count B)
2 Dual display UNIT A
(Count A)
UNIT A
(Count A)
UNIT B
(Count B)
UNIT B
(Count B)
3 Memory display UNIT A
(Count A)
UNIT F
(Memory)
UNIT B
(Count B)
UNIT F
(Memory)
4 Speed display UNIT A
(Count A)
UNIT D
(Speed A)
UNIT B
(Count B)
UNIT E
(Speed B)
5 Optional display
(1 CEL)
UNIT A to F - - -
6 Optional display
(2 CELs)
UNIT A to F UNIT A to F - -
7 Optional display
(4 CELs)
UNIT A to F UNIT A to F UNIT A to F UNIT A to F
Tips
The Display mode also controls the number of output data for the external output
function (Digimatic output and RS-232C output).
When setting up the system using the external output function, pay attention to the
number of output data.
e.g. Selecting the setup value 1: Two selected BANK data are output with the
Digimatic output; four data items are output by the displayed data output (GA00CRLF)
with the RS-232C output.
Selecting the setup value 5: One selected BANK data is output with the Digimatic
output; one data item is output by the displayed data output (GA00CRLF) with the RS-
232C output.
Display mode types
z
Coordinate display (set value: 0)
Displays 2 sets of coordinates using the BANK function.
Tips
• The origin and tolerance can be set separately for INPUT A and INPUT B.
• For details about BANK switchover, see
"4.2 Switching the Displayed BANK (2-Axis
Models Only)" (page 25).
To Next Page
Loading...