Mitutoyo LSM-9506 - Page 10

No. 99MBC032A viii
b. Setting the RS-232C communication baud rate
(Guidance: BAUD)........................................................... 4-12
c. Setting the RS-232C communication data bits
(Guidance: LENGTH) ...................................................... 4-12
d. Setting the RS-232C communication parity bit
(Guidance: PARITY)........................................................ 4-13
e. Setting the delimiter for communication
(Guidance: DELIMT)........................................................ 4-13
f. Setting the RS-232C line control
(Guidance: CONTRL) ...................................................... 4-13
4.1.2.6 B5: Reserved ........................................................................ 4-14
4.1.2.7 Selecting and setting the function in the B6 mode .............. 4-14
a. Setting the use of DCU (Guidance: DCU) ...................... 4-14
4.2 Calibration ................................................................................................... 4-15
4.2.1 Calibration gages and gage stand ................................................. 4-15
4.2.2 Entering the calibration mode......................................................... 4-15
4.3 Positioning a Gage or a Workpiece............................................................ 4-19
4.4 How to read-in the amount of light ............................................................. 4-19
4.5 Setting Up the Functions ............................................................................ 4-20
4.5.1 Outline of the function setup mode ................................................ 4-20
4.5.2 Outline of each function setup mode ............................................. 4-22
4.5.3 Function setup mode ...................................................................... 4-23
4.5.3.1 F0: Setting the segment ....................................................... 4-23
4.5.3.2 F1: Setting the measurement interval
(measurement time) ............................................................. 4-25
4.5.3.3 F2: Setting the GO/NG judgment criteria ............................. 4-27
4.5.3.4 F3: Setting the reference value ............................................ 4-31
4.5.3.5 F4: Setting the offset value .................................................. 4-32
4.5.3.6 F5: Setting the data output conditions ................................. 4-34
4.5.3.7 F6: Setting the sample measurement .................................. 4-35
4.5.3.8 F7: Automatic workpiece detection setting .......................... 4-36
4.5.3.9 F8: Setting the group judgment............................................ 4-37
4.5.3.10 Confirming the function setup contents................................ 4-38
5. MEASUREMENT MODE ...................................................................................... 5-1
5.1 Outline of the Measurement Mode ............................................................... 5-1
5.1.1 Setup in the measurement mode ..................................................... 5-1
5.1.1.1 Setup operation from the arrow key....................................... 5-2
5.1.1.2 Setup that can be made directly from each setup item key .. 5-4
5.2 Other Functions ............................................................................................ 5-5
5.2.1 Key lock ............................................................................................ 5-5
5.2.2 Displaying the measuring position.................................................... 5-5
5.3 Applied Measurement ................................................................................... 5-6
5.3.1 OD measurement of a precision-machined workpiece .................... 5-6
5.3.2 Measurement of magnet coil wire that runs at high speed.............. 5-7
5.3.3 Measurement of the lead pitch of a multiple-pin IC ......................... 5-8
5.3.4 Applied Measurement with Offset/Zero-Set Functions................... 5-10
5.3.5 Sample measurement..................................................................... 5-13
5.3.6 Applied measurement with automatic workpiece detection ........... 5-15
5.3.7 Applied measurement on a stepped round bar.............................. 5-17