Mitutoyo LSM-9506 - Other Commands

6 - 12 No. 99MBC032A
6.1.8 Other commands
1) Each of the D, R, and CR commands can be appended with an “N”.
If appended with an “N”, each program number will be removed from these commands.
Item Reception command
Data request
Single-run measurement (zero-run measurement)
Continuous-run measurement
DN
RN
CRN
Example: “D” → “P0, 12.3456” : Appended with a program number
“DN” → “12.3456” : Program number is removed.
2) Each of the D, R, CR, RP, STAT, and RA commands can be appended with an “*”.
If appended with an “*”, these commands have a fixed data length that is not zero-sup-
pressed.
Item Reception command
Data request
Single-run measurement (zero-run measurement)
Continuous-run measurement
Request of measuring conditions list
Request of statistical processing results
Request of automatic workpiece detection conditions list
*D
*DN
*R
*RN
*CR
*CRN
*RP
*STAT
*RA
Example: “D” → “P0, 12.3456” : Zero suppressed.
“*D” → “P0, +012.3456” : Outputted in 7 digits without zero suppressing.